Is it hard to get hired as a Verification Design Engineer at DEKA Research and Development?

Verification Design Engineer applicants have rated the interview process at DEKA Research and Development with 2 out of 5 (where 5 is the highest level of difficulty) and assessed their interview experience as 100% positive. To compare, the company-average is 54.3% positive. This is according to Glassdoor user ratings.

How long does it take to get hired as a Verification Design Engineer at DEKA Research and Development?

Candidates applying for Verification Design Engineer roles take an average of 3 days to get hired, when considering 1 user submitted interviews for this role. To compare, the hiring process at DEKA Research and Development overall takes an average of 19 days.

Where can I find DEKA Research and Development interview experiences by job title?

Software Engineer (24) ; Mechanical Engineer (15) ; Test Engineer (13) ; Intern (10) ; Engineer (9) ; Test Technician (8) ; Control Systems Engineer (7) ; Manufacturing Engineer (5) ; QA Test Technician (4) ; Quality Assurance Test Technician (4) ; Senior Software Engineer (4) ; Software Developer (4) ; Systems Engineer (4) ; Controls Engineer (3) ; Electrical Engineer (3)

DEKA Research and Development Verification Design Engineer Interview Questions

Skip to content Skip to footer

Notifications

DEKA Research and Development

Interviews

Verification Design Engineer Interview

May 27, 2018

Anonymous Interview Candidate

No offer

Positive experience

Easy interview

Application

I applied through a recruiter. The process took 3 days. I interviewed at DEKA Research and Development (New York, NY) in May 2018

Interview

The interviews was broken down into 20 min the interviewer describing himself and DEKA, 20 min of me speaking to my own skills and experience, and 20 minutes of technical questions. 1 hour total.

Interview questions [2]

Question 1

A large spool has a rope wrapped around in a counterclockwise fashion. The rope is pulled by a force acting to the right such that the rope is pulled from under the spool. What direction will the spool roll if the system is affected by friction?

1 Answer

Question 2

Series circuit analysis. (Going clockwise) there is a 1A current source followed by a 2 Ohm resistor followed by a 5V voltage source (negative pole connected to resistor). The current flows clockwise. What is the voltage across the current source?

Answer question

Jobs at DEKA Research and Development

Verification & Validation Test Engineer

Manchester, NH

View job

Quality Systems Engineer – CAPA and Process Improvement

Software Quality Assurance Engineer

Manchester, NH

View job

Failure Analysis Engineer

Robotics Control Systems Engineer

DEKA Research and Development interviews FAQs

DEKA Research and Development interviews DEKA Research and Development Verification Design Engineer interviews DEKA Research and Development interview

DEKA Research and Development

Verification Design Engineer Interview

Jobs at DEKA Research and Development

DEKA Research and Development interviews FAQs

Want the inside scoop on your own company?

Bowls

Followed companies

Job searches

Verification Design Engineer Interview

DEKA Research and Development interviews FAQs

Jobs at DEKA Research and Development