Active inductor formula
Analog Mixed Signal Design Engineer Interview Questions
58 analog mixed signal design engineer interview questions shared by candidates
feedback analysis, biasing, class-a amplifier basics
Analog Fundamentals: Differential pairs, current mirrors, frequency response, linearity, noise, matching, ...
Question on op-amp, control systems, pll, vco, bjt, cmos was asked
Can you give a brief introduction about the structure of the NMOS ?
Strong arm latch. Describe output waveform from the initial phase to the final state
R-RC-R circuit. What is the step response?
Mostly very basic Device Physics questions. Not very complicated and some of the questions were: 1. Describe the operation of NMOS and PMOS, 2. What is body effect? How does it affect the gate voltage. 3. Describe the operating regions of NMOS transistor 4. If gate voltage is 2V and drain voltage is is 2V what is the source voltage? 5. What factors affect threshold voltage? Explain them 6. What is channel length modulation?
Viewing 51 - 60 interview questions