Controls Specialist applicants have rated the interview process at CONVERGIX Automation Solutions with 2.5 out of 5 (where 5 is the highest level of difficulty) and assessed their interview experience as 50% positive. To compare, the company-average is 46.1% positive. This is according to Glassdoor user ratings.
Candidates applying for Controls Specialist roles take an average of 31 days to get hired, when considering 4 user submitted interviews for this role. To compare, the hiring process at CONVERGIX Automation Solutions overall takes an average of 32 days.
Common stages of the interview process at CONVERGIX Automation Solutions as a Controls Specialist according to 4 Glassdoor interviews include:
IQ intelligence test: 18%
Phone interview: 18%
Personality test: 18%
One on one interview: 18%
Skills test: 18%
Group panel interview: 9%
Here are the most commonly searched roles for interview reports -
I applied online. The process took 3 weeks. I interviewed at CONVERGIX Automation Solutions (Burlington, ON)
Interview
I applied online. After 2 weeks I had a phone interview and then an online assessment which took more then two hours. It contains about 200 questions. They asked me to set up a PLC and AutoCAD test. It should be printed, scanned and emailed. After that AutoCAD test was started and it schematics. One hour was given to each test.
Interview questions [1]
Question 1
Describe an event when you solved a problem in PLC logic?
Interview process was for a junior position. It was lightly technical but not as difficult as I expected. They asked about past skills but I was not required to program or design anything.
Interview questions [1]
Question 1
Can you explain why you’d be a good fit to the JMP team.
I applied online. The process took 3 weeks. I interviewed at CONVERGIX Automation Solutions (Burlington, ON) in Aug 2015
Interview
The hiring process started with a phone interview and it continued with an online assessment which took about two hours. It contains a lot of questions. They asked me to set up a PLC test. It should be printed, filled, scanned and emailed. It should be done in one hour. After that AutoCAD test was started and it was same as the PLC test.